
Tools & Accessories
Heat shrink tube set
৳55
- Fresh, latest-batch stock — never old shelf stock
- Tested before it ships
- Arrives dead? We replace it
- Same-day delivery in Dhaka · Cash on Delivery nationwide
- See it before you buy: visit our shop at Ansar Ali Sarak, Boat Ghat, East Nurer Chala, Vatara
Heat shrink tube set is an assorted kit of pre-cut polyolefin tubing in a compartment box, with diameters from about 0.6mm up to 13mm. Slide a tube over a solder joint or a splice, heat it with a lighter or heat gun, and it shrinks to half its diameter, giving an insulated, strain-relieved finish that tape cannot match.
- Flame-retardant polyolefin with a 2:1 shrink ratio
- Pre-cut pieces of roughly 48mm, so no cutting from a long roll
- Multiple colours for polarity and wire-group coding
- Full shrink at about 100-110°C, 600V insulation class
Pick a tube that slides over the joint easily but is clearly smaller than it, since it only shrinks to half its supplied size.
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
| Category | Tools & Accessories |
| Model no. | HST-SET |
| Availability | Out of stock — request notify |
| Delivery | Cash on Delivery, nationwide Bangladesh |
| Material | flame-retardant polyolefin |
| Shrink Ratio | 2:1 — shrinks to half the supplied diameter |
| Diameter Range | approx 0.6 mm to 13 mm across the assortment |
| Cut Length | pre-cut pieces, approx 48 mm each |
| Assortment | multiple diameters and colours in a compartment storage box |
| Full Shrink Temperature | approx 100°C - 110°C |
| Shrink Start | begins to soften at about 70°C - 80°C |
| Operating Temperature | -55°C to +125°C continuous |
| Rated Voltage | 600 V insulation class |
| Flammability | flame-retardant, self-extinguishing |
| Typical Uses | wire splices, solder joint insulation, cable repair, connector sleeving |
Customer reviews
No reviews yet — be the first.
Questions about the Heat shrink tube set
What is a heat shrink tube set used for?
The tubes slide over a wire joint, solder splice or connector, and when heated they shrink tight around it, insulating the metal, relieving strain and finishing the repair cleanly.
How do I use the tubing properly?
Slip the tube onto the wire before you solder or twist the joint, position it fully over the finished joint with overhang on both sides, then apply even heat while turning until it shrinks snug.
Which diameter tube should I choose?
One that slides over the joint easily but is clearly smaller than it, because it only shrinks to half. A tube about 20-30% larger than the joint gives a firm, wrinkle-free fit.
Can I shrink it with a lighter instead of a heat gun?
Yes. Keep the flame moving and hold the tube a little above the visible flame so it shrinks from radiant heat without scorching. A hair dryer also works on small sizes.
How much heat does it survive in service?
The polyolefin is rated for continuous use from -55°C to +125°C, which covers robot chassis, chargers and outdoor boxes, as long as the tube is not sitting in a flame.
দাম কত এবং কোথায় পাবো?
সর্বশেষ দাম এই পেজের ওপরে আছে; 'Contact for price' লেখা থাকলে WhatsApp-এ মেসেজ দিয়ে রেট জেনে নিন। অর্ডার করলে সারা দেশে কুরিয়ারে যায়।


