Skip to content
Capacitors

470uf 50v Capacitor

৳16

The 470uf 50v capacitor is a bulk reservoir with real energy behind it: 470 microfarads rated 50V, ready to feed motor starts, amplifier bass hits and the input side of DC-DC converters. Across the output of a bridge rectifier it turns raw pulsating DC into usable smooth DC, and beside a 24V motor driver it stops the rail sagging every time the motor kicks in.

  • 470uF at approx ±20% tolerance, 50V DC
  • High ripple current, suited to bulk reservoir duty
  • Polarized: longer lead positive, stripe marks negative
  • Approx 10 x 20 mm can, 3.5 mm lead spacing
  • Rated -40°C to +105°C, 1000 hour load life

This is also the standard repair value for switch-mode supplies, chargers and audio amplifiers, which is why service benches buy it in packs. To order, send the part name to Tekko on WhatsApp; cash on delivery, delivered across Bangladesh.

Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.

Capacitance: 470uF (470 microfarads)

Rated Voltage: 50V DC

Tolerance: approx ±20%

Type: Aluminum Electrolytic

Mounting: Radial Through-Hole

Polarity: Polarized — longer lead is positive, stripe marks negative

Lead Spacing: approx 3.5mm

Body Size: approx 10mm diameter x 20mm height (typical)

Temperature Range: -40°C to +105°C

Load Life: 1000 hours at rated temperature

Ripple Current: high, suited to bulk reservoir duty

Typical Uses: rectifier output smoothing, SMPS and charger repair, motor-drive rail support, amplifier reservoir

CategoryCapacitors
Model no.CAP-470UF-50V
AvailabilityIn stock
In stock20 pcs
DeliveryCash on Delivery, nationwide Bangladesh

Customer reviews

No reviews yet — be the first.

Questions about the 470uf 50v Capacitor

What is a 470uF 50V capacitor most commonly used for?
Bulk smoothing and reservoir duty — across a rectifier output to make smooth DC, at the input of DC-DC converters, beside motor drivers, and as the standard replacement can in SMPS and charger boards.
How does it turn rectified AC into usable DC?
Connected across the bridge rectifier output with correct polarity, it charges at each pulse and discharges into the load between pulses, collapsing the ripple dramatically.
Can it run on a 12V car or solar setup?
Yes — 12V is far inside the 50V rating; the big reserve is especially useful where pumps, motors or inverters cause voltage dips.
Why must polarity never be reversed?
A large electrolytic in reverse builds heat and pressure quickly and can vent violently — the stripe must always face the negative node.
Is a higher voltage rating a problem if unused?
No — a 50V part on a 12V rail simply runs cooler and lasts longer; capacitance behaviour stays the same.
How do I discharge it safely before handling?
Briefly connect a 1k to 10k resistor across the leads; never short a charged 470uF directly, as the spark and stress damage both part and terminals.
Will it fix a humming amplifier or blinking charger?
Very often yes — dried-out 470uF cans are the number-one cause of hum and blink codes in aging PSUs and amplifiers, and swapping them restores normal operation.
470uf 50v ক্যাপাসিটরের দাম কত?
সর্বশেষ দাম Tekko প্রোডাক্ট পেজে দেখুন — ওখানেই সর্বশেষ প্রাইস দেওয়া থাকে।
এই বড় ক্যাপাসিটরটা কোথায় পাবো?
Tekko অনলাইন স্টোরে স্টকে আছে; অর্ডার করলে সারা বাংলাদেশে হোম ডেলিভারি করা হয়।
পাওয়ার সাপ্লাই রিপেয়ারে এটা কী কাজে লাগে, কেনো করবো?
SMPS, চার্জার আর অ্যামপ্লিফায়ারের মেইন ফিল্টার ক্যাপাসিটর হিসেবেই এটা সবচেয়ে বেশি নষ্ট হয়, তাই রিপেয়ার বেঞ্চে এই ভ্যালুটা অবশ্যই রাখতে হয়।
সার্কিটে কিভাবে লাগাবো সঠিকভাবে?
রেক্টিফায়ার বা রেগুলেটরের + আউটপুটে লম্বা লিড, GND-তে দাগের লিড দিন — চার্জ থাকলে 1k রেজিস্টর দিয়ে ডিসচার্জ করে তারপর হাতে নিন।
মোটর ড্রাইভারের সাথে কি সত্যিই পার্থক্য বোঝা যায়?
হ্যাঁ — মোটর চালু হওয়ার মুহূর্তে রেল ঝাঁকি কমে যায়, মাইক্রোকন্ট্রোলার রিসেট হওয়া বন্ধ হয়, আর ড্রাইভার আরও স্থিতিশীল চলে।