Skip to content
Modules

CD74HC4067 16-Channel Analog Digital Multiplexer Breakout Board Module Smart Electronics

৳265

The CD74HC4067 16-channel analog/digital multiplexer breakout routes any one of 16 signal lines through a single common pin, and four address pins decide which one. One ADC input can then read sixteen sensors, or one digital pin can drive sixteen outputs, which is the classic fix when an Arduino or ESP32 has run out of analog pins and a soil-moisture grid, button bank or LED array still needs wiring.

  • 16 single-ended channels into one common input/output pin
  • S0-S3 address pins plus an active-low EN pin
  • Passes analog and digital signals in both directions
  • 2-6V supply; signals must stay between GND and VCC
  • 2.54mm through-hole headers, breadboard friendly

Each channel adds roughly 70-120 ohm of on-resistance, no problem for sensor reads and LEDs, but put a resistor in series with anything that draws serious current.

Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.

Chip: CD74HC4067 high-speed CMOS 16-channel analog multiplexer

Channels: 16 single-ended signal lines to 1 common pin

Supply Voltage: 2 - 6 V DC

Signal Range: signals must stay between GND and VCC

Control: 4 address pins S0-S3 plus active-low enable (EN)

On Resistance: approx. 70 - 120 ohm depending on supply voltage

Signal Type: analog or digital, bidirectional

Interface: 2.54 mm through-hole headers on breakout

Logic Compatibility: 5 V Arduino and 3.3 V ESP32 within supply limits

Typical Uses: 16-sensor analog arrays, button banks, LED selectors, data logging

CategoryModules
Model no.CD74HC4067
AvailabilityIn stock
In stock3 pcs
DeliveryCash on Delivery, nationwide Bangladesh

Customer reviews

No reviews yet — be the first.

Questions about the CD74HC4067 16-Channel Analog Digital Multiplexer Breakout Board Module Smart Electronics

What problem does the CD74HC4067 module solve?
It multiplies your pin budget - sixteen sensors or signals share one analog pin and four digital address pins, so an Arduino Uno reads 16 analog channels instead of only 6.
How do I select a channel in code?
Write the channel number 0-15 as 4 bits onto the S0-S3 pins, wait a moment for the switch to settle, then read or write the common pin - channel 13, for example, is HIGH-LOW-HIGH-HIGH.
Can it pass analog values, not just on-off signals?
Yes - it is a transmission gate, so it faithfully passes voltages between 0 V and VCC in either direction, which is why it works for both ADC reading and PWM or digital output distribution.
How do I connect it to an ESP32 or 3.3 V board?
Power it from 3.3 V instead of 5 V so the passed signals never exceed the supply, then wire S0-S3 and the common pin to normal GPIO and ADC pins; no level shifter is needed within the same supply.
What is the enable pin for?
Pulling EN high disconnects all 16 channels at once, which lets several multiplexers share one common line, or simply saves power between readings in battery projects.
Can it switch motors or LED strips directly?
No - the chip passes signals up to around 20 mA; use it to select or gate control lines, and drive actual loads through transistors, MOSFETs or relays.
Why do my analog readings drift between channels?
The on-resistance and source impedance need settling time, so add a small delay after switching channels and a 100 nF capacitor from the common pin to ground, or read twice and keep the second value.
CD74HC4067 মাল্টিপ্লেক্সার মডিউলের দাম কত?
সর্বশেষ দাম Tekko প্রোডাক্ট পেজে দেখুন - Tekko-তে সেরা দামে পেজে আপডেটেড প্রাইস দেওয়া থাকে।
অনলাইনে এই ব্রেকআউট বোর্ড কোথায় কিনবো?
Tekko অনলাইন স্টোরে স্টকে আছে, অর্ডার করলে সারা বাংলাদেশে হোম ডেলিভারিতে পৌঁছে যাবে।
কম পিনে বেশি সেন্সর পড়তে এটা কী কাজে লাগে?
১৬টা সেন্সরের সিগন্যাল একটা কমন পিনে পালা করে পাঠায়, তাই Arduino-র ৬টা অ্যানালগ পিন দিয়েই ১৬টা সয়েল ময়েসচার বা সেন্সর পড়া যায়।
Arduino-র সাথে কিভাবে লাগাবো?
VCC-GND দিন, S0-S3 চারটা ডিজিটাল পিনে আর কমন সিগ পিন A0-তে যুক্ত করুন - কোডে চ্যানেল নম্বর ৪ বিটে পাঠিয়ে দিলেই সেই সেন্সর অ্যানালগ পিনে চলে আসবে।
কোন ধরনের প্রজেক্টে সবচেয়ে কাজের?
গাছের পাতায় ১৬ জায়গায় ময়েসচার পড়া, বড় বাটন প্যানেল, সেন্সর অ্যারে ডাটা লগিং - যেখানেই পিন কম পড়ছে, সেখানেই এই মডিউল জীবন বাঁচায়।