
Modules
MicroSD Card Module
Contact for price
- Fresh, latest-batch stock — never old shelf stock
- Tested before it ships
- Arrives dead? We replace it
- Same-day delivery in Dhaka · Cash on Delivery nationwide
- See it before you buy: visit our shop at Ansar Ali Sarak, Boat Ghat, East Nurer Chala, Vatara
The MicroSD card module is a small SPI breakout that lets an Arduino write files to a standard microSD card. It is the storage half of a data logger: temperature and humidity readings, GPS tracks, soil moisture logs, all saved to a card you pull out and open on a laptop. The onboard regulator accepts 3.3-5V supply, and the SD library built into the Arduino IDE does the work.
- SPI interface, four signal wires: CS, SCK, MOSI, MISO
- Onboard regulator, runs from 3.3-5V
- Uses FAT16/FAT32 formatted cards
- Works with the standard Arduino SD library, nothing extra to install
Format the card as FAT32 in a computer before first use. Most no-card-found errors are a formatting problem, not a wiring one.
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
| Category | Modules |
| Model no. | MICROSD-MODULE |
| Availability | Sourced on request — ask for price & lead time |
| Delivery | Cash on Delivery, nationwide Bangladesh |
| Interface | SPI |
| Operating Voltage | 3.3-5V (onboard regulator) |
| Supports | FAT16/FAT32 formatted cards |
Customer reviews
No reviews yet — be the first.
Questions about the MicroSD Card Module
What is the MicroSD card module used for?
Saving data from a project onto a microSD card: sensor logs, GPS tracks, timestamps, images from a camera module. Anything you want to keep after the power goes off.
Does it work with Arduino and ESP32?
Yes, both, over SPI. On an Arduino Uno use pins 11 to 13 with chip select on 10; on an ESP32 pick a free GPIO for CS and set the SPI pins in your code.
What size card can I use?
Cards up to 32GB formatted as FAT16 or FAT32 are the safe choice. Large exFAT cards are not supported by the standard SD library.
Why does my sketch say card initialization failed?
Format the card as FAT32 first, check the chip-select pin number in the code matches your wiring, and keep the jumper wires short. Sharing the SPI bus with another module can also cause it.
সারা দেশে ডেলিভারি হয়?
হ্যাঁ, সারা বাংলাদেশে ডেলিভারি করা হয় এবং Cash on Delivery সুবিধা আছে। কুরিয়ার চার্জ অর্ডারের আগে WhatsApp-এ জানিয়ে দেওয়া হয়।


