
Tilt Switch Sensor Module
- Fresh, latest-batch stock — never old shelf stock
- Tested before it ships
- Arrives dead? We replace it
- Same-day delivery in Dhaka · Cash on Delivery nationwide
- See it before you buy: visit our shop at Ansar Ali Sarak, Boat Ghat, East Nurer Chala, Vatara
The Tilt Switch Sensor Module is a ball-type tilt switch on a breakout board: the ball rolls with gravity and the digital output changes as soon as the board tips past a small angle. Anti-theft alarms, posture reminders and fall-over detection on robots are what it gets used for.
- Ball-type tilt switch, digital output changing past a small angle
- 3.3 to 5V supply, three pins: VCC, GND and DO
- Negligible current draw, so it suits battery-powered alarms
- Breadboard-friendly through-hole breakout
A WhatsApp message is all it takes to order.
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
Switch Type: Ball-type tilt switch
Output: Digital, changes state when tilted past a small angle
Supply Voltage: 3.3-5 V DC
Pins: 3 (VCC, GND, DO) on typical modules
Conditioning: Onboard circuitry provides a defined digital level
Trigger Action: Tilting the module beyond a small angle from upright
Interface: digitalRead on any MCU GPIO, debounce recommended
Applications: Anti-theft alarms, posture and orientation detection, fall-over alerts
Mounting: Through-hole breakout, breadboard friendly
Current Draw: Negligible, suitable for battery-powered alarms
| Category | Sensors |
| Model no. | TILT-BALL |
| Availability | In stock |
| In stock | 5 pcs |
| Delivery | Cash on Delivery, nationwide Bangladesh |
Customer reviews
No reviews yet — be the first.
Questions about the Tilt Switch Sensor Module
What is a tilt switch sensor module used for?
It tells your board that the module has tipped past a small angle, which covers anti-theft alarms, fall-over detection on robots, posture reminders and simple orientation sensing.
Tilt switch or accelerometer, which one do I need?
A tilt switch gives you a cheap tipped-or-not signal. Pick an MPU6050-style accelerometer when you need the actual angle, vibration magnitude or motion tracking.
How do I connect it to an Arduino?
Power from 3.3V or 5V and ground, output to any input pin, then digitalRead it or attach an interrupt for an instant response.
Is this a good first sensor for a beginner?
Yes. Three wires and one digitalRead, and the result shows up in the Serial Monitor immediately.
Is it waterproof or suitable for outdoor use?
No, it is an open breakout module. Put it in an enclosure if rain, dust or constant vibration is part of the project.
Why does the reading bounce right at the tilt point?
The rolling ball makes and breaks contact, so you get bounce near the threshold. Debounce in code, add a small capacitor across the output, or mount it away from the exact trigger angle.


