
Sensors
Water Level Sensor Depth of Detection Water Sensor for Arduino
৳55
- Fresh, latest-batch stock — never old shelf stock
- Tested before it ships
- Arrives dead? We replace it
- Same-day delivery in Dhaka · Cash on Delivery nationwide
- See it before you buy: visit our shop at Ansar Ali Sarak, Boat Ghat, East Nurer Chala, Vatara
The Water Level Sensor Depth of Detection Water Sensor for Arduino is a slim resistive PCB whose parallel traces report immersion depth as an analog voltage, so an Arduino ADC pin reads the level directly. Tank level indicators and rain detection are what it gets bought for.
- Analog output rises as more of the strip goes under water
- Supply approx 3.3 to 5V, current draw below 10mA
- Three pins: S for the analog signal, plus VCC and GND
- About 65 x 20mm with mounting holes, so it fits tanks and gutters
- Power it only while measuring and the traces last far longer
Order through WhatsApp with Cash on Delivery anywhere in the country.
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
| Category | Sensors |
| Model no. | WLS-ANALOG |
| Availability | In stock |
| In stock | 4 pcs |
| Delivery | Cash on Delivery, nationwide Bangladesh |
| Type | Resistive parallel-trace water level sensor |
| Output | Analog voltage that rises with immersion depth |
| Supply Voltage | approx 3.3-5V DC |
| Working Current | below 10 mA typical |
| Interface | 3 pins - S (analog signal), VCC and GND (typical pinout) |
| Board Size | approx 65 x 20 mm |
| Detection | Water contact along the exposed trace section |
| Works With | Arduino ADC, ESP32 ADC, ESP8266 A0, Raspberry Pi via external ADC |
| Mounting Holes | 3 mm holes on the PCB (typical) |
| Applications | Tank level indicator, rain detection, plant watering, overflow alarm |
Customer reviews
No reviews yet — be the first.
Questions about the Water Level Sensor Depth of Detection Water Sensor for Arduino
What is this water level sensor used for?
It reports how deep the board sits in water. The wetted traces change resistance with depth and the module turns that into an analog voltage your board reads as a level.
How do I wire it to an Arduino?
S to an analog input such as A0, VCC to 5V or 3.3V and GND to ground. analogRead the pin and watch the number climb as the water rises.
How do I turn readings into actual depth?
Dip the sensor to a few known depths, write down the ADC values at each mark and map those numbers in code. Your own marks beat any generic formula.
Does it work with ESP32, ESP8266 or Raspberry Pi?
Any board with an ADC input works. The Pi has no analog inputs, so add a small external ADC such as the ADS1115.
How does it compare with an ultrasonic level sensor?
Ultrasonic measures from above without touching the water and suits big tanks. This contact sensor is simpler for small tanks, pots and rain detection, at the cost of occasional cleaning.
পানিতে সবসময় ডুবিয়ে রাখলে কি সমস্যা হবে?
ট্রেসে ধীরে মরিচা পড়তে পারে। মাপার সময় পাওয়ার অন করে মাপা শেষে অফ রাখুন, আর ব্যবহারের পর মুছে শুকিয়ে রাখলে সেন্সর বহুদিন ভালো থাকে।

