
SS49E Linear Hall Effect Module
- Fresh, latest-batch stock — never old shelf stock
- Tested before it ships
- Arrives dead? We replace it
- Same-day delivery in Dhaka · Cash on Delivery nationwide
- See it before you buy: visit our shop at Ansar Ali Sarak, Boat Ghat, East Nurer Chala, Vatara
The SS49E Linear Hall Effect Module converts a magnetic field into a smooth analog voltage that a microcontroller ADC pin reads directly. Door and lid sensors, RPM measurement with a magnet on a rotating shaft, contactless position or throttle controls and magnetic joysticks all come out of this one part.
- Output sits near half the supply with no magnet, then rises or falls with field strength
- North and south poles push the output in opposite directions, so it reads polarity too
- About 2 mV per Gauss at 5V, linear across roughly plus or minus 1000 Gauss
- VCC, GND and OUT on a 3-pin header; no library, one analogRead is enough
Power it from 5V as specified; on a 3.3V ESP32 input, add a divider on OUT so the swing stays in range.
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
Sensor: SS49E linear Hall-effect IC on breakout board
Supply Voltage: 4.5-5.5 V DC (5 V recommended)
Output Type: Analog voltage, ratiometric to supply
Zero-field Output: approx. half of supply voltage (about 2.5 V at 5 V)
Sensitivity: approx. 2 mV per Gauss at 5 V
Usable Field Range: approx. ±1000 Gauss linear span
Polarity Response: north and south poles drive output in opposite directions
Interface: 3 pins - VCC, GND, OUT (2.54 mm header)
Response: continuous analog tracking, fast magnetic response
Board Size: approx. 25 x 15 mm
Typical Interface: microcontroller ADC input, no library required
Weight: approx. 3 g
| Category | Modules |
| Model no. | SS49E |
| Availability | In stock |
| In stock | 11 pcs |
| Delivery | Cash on Delivery, nationwide Bangladesh |
Customer reviews
No reviews yet — be the first.
Questions about the SS49E Linear Hall Effect Module
What is the difference between linear and digital hall sensors?
A digital hall like the 3144 just switches on or off near a magnet. The linear SS49E outputs a voltage proportional to field strength, so you can also measure strength and position.
How do I read it with an Arduino?
Power it from 5 V, connect OUT to an analog pin, and analogRead gives about 512 with no magnet. The value rises or falls smoothly as a magnet approaches.
Can it tell north from south pole?
Yes. One pole pushes the output above the midpoint and the opposite pole pulls it below, so the direction of the change shows the polarity.
Can I use it with 3.3 V boards like the ESP32?
Power the module from 5 V as specified and put a simple voltage divider on OUT so the swing stays inside the 3.3 V ADC range.
Does it need a resistor or library?
No library is needed. Wire VCC, GND and OUT and read it with one analogRead; add a capacitor across the supply only if readings look noisy.
How close does a magnet need to be?
A small neodymium magnet influences it strongly within a few millimetres. A weak ferrite magnet needs to sit closer for a full swing.


