
TTP223 Touch Sensor Module for Arduino
- Fresh, latest-batch stock — never old shelf stock
- Tested before it ships
- Arrives dead? We replace it
- Same-day delivery in Dhaka · Cash on Delivery nationwide
- See it before you buy: visit our shop at Ansar Ali Sarak, Boat Ghat, East Nurer Chala, Vatara
The TTP223 Touch Sensor Module for Arduino replaces a mechanical push button with a capacitive pad, putting out a clean digital signal when a fingertip comes near. Touch lamps and hidden switches behind cabinet doors are where it usually ends up.
- TTP223 capacitive IC, single digital output pin
- 2.0 to 5.5V supply, so it runs straight from 3.3V boards
- Solder pads select momentary or toggle, active-high or active-low
- Extend the pad with wire or foil and it triggers through a thin plastic, wood or glass panel
To order one, message us on WhatsApp.
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
IC: TTP223 capacitive touch detector
Output: Digital high/low according to pad selection
Supply Voltage: 2.0-5.5 V DC
Modes: Momentary or toggle, selected by solder pad
Output Polarity: Active-high or active-low, selected by solder pad
Interface: Single output pin to any MCU GPIO
Touch Pad: Onboard pad, extendable with wire or foil
Panel Trigger: Works through thin non-conductive panels
Power: Low standby consumption, battery friendly
Applications: Touch lamps, hidden switches, capacitive buttons, doorbells
| Category | Sensors |
| Model no. | TTP223 |
| Availability | In stock |
| In stock | 5 pcs |
| Delivery | Cash on Delivery, nationwide Bangladesh |
Customer reviews
No reviews yet — be the first.
Questions about the TTP223 Touch Sensor Module for Arduino
What is the TTP223 touch sensor module?
A small capacitive touch board that outputs a digital signal when you touch its pad, a silent, wear-free replacement for a push button.
How do I wire the TTP223 to an Arduino?
VCC to 3.3V or 5V, GND to ground and the SIG output to any digital input, then read it with digitalRead exactly like a normal button.
How do I change it from momentary to toggle mode?
Use the A/B solder pads on the back. One pair selects momentary or toggle behaviour, the other selects active-high or active-low output.
Can I mount it behind a panel?
Yes. Solder a wire or stick a strip of foil to the pad and place it behind thin plastic, glass or wood. Keep the lead short, because a longer pad raises sensitivity and can leave the output latched on.
Does it work with ESP32 and other 3.3V boards?
Yes, the 2.0 to 5.5V supply range means it runs directly from an ESP32 or Raspberry Pi 3.3V rail with no level shifting.
ব্যাটারি চালিত প্রজেক্টে চলবে তো?
চলবে। স্ট্যান্ডবাই কারেন্ট কম এবং 2.0-5.5V পর্যন্ত চলে, তাই ব্যাটারি প্রজেক্টে ভালোভাবে কাজ করে।


