
Modules
Water Level Sensor Float Switch
৳95
- Fresh, latest-batch stock — never old shelf stock
- Tested before it ships
- Arrives dead? We replace it
- Same-day delivery in Dhaka · Cash on Delivery nationwide
- See it before you buy: visit our shop at Ansar Ali Sarak, Boat Ghat, East Nurer Chala, Vatara
The Water Level Sensor Float Switch is a two-wire vertical float switch with a sealed reed contact that opens or closes as the water level moves the float. Automatic overhead-tank filling, low-level pump cutoff and flood alarms are the everyday uses, and because it is a passive switch it needs no power supply and no microcontroller to do its job.
- Sealed PP plastic body, made for clean, non-viscous water
- Handles up to 220V at 0.5A, enough for a relay or contactor coil
- About 35cm of two-core cable pre-attached, no polarity
- Mount it one way for normally-open behaviour, flip it for normally-closed
For a household pump, let the switch drive a relay or contactor instead of passing the motor current through the float.
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
| Category | Modules |
| Model no. | ZP4510 |
| Availability | In stock |
| In stock | 4 pcs |
| Delivery | Cash on Delivery, nationwide Bangladesh |
| Type | Vertical-mount float level switch (reed contact inside float) |
| Wires | 2-core cable pre-attached, approx. 35 cm |
| Max Switching Voltage | 220 V AC / DC |
| Max Switching Current | 0.5 A |
| Contact Behaviour | depends on orientation - hangs closed, raised open (or reverse) |
| Operating Temperature | 0 to 60 °C |
| Liquid Type | clean, non-viscous, non-crystallising water-based liquids |
| Body Material | moulded PP plastic, sealed against water ingress |
| Mounting | vertical, through the tank top with grommet or bracket |
| Overall Length | approx. 100 mm including float |
| Suitable Controllers | relay module, contactor coil, Arduino/ESP digital input |
Customer reviews
No reviews yet — be the first.
Questions about the Water Level Sensor Float Switch
What does a water level float switch do?
It is a mechanical switch sealed inside a float. As the water level rises or falls the float tilts and the internal contact opens or closes, signalling a controller or directly switching a small load.
How do I wire this float switch?
It has just two wires with no polarity. Put it in series with a relay coil or pump contactor, or between an Arduino digital input and GND using INPUT_PULLUP in code.
Can it switch my water pump directly?
Only very small pumps under 0.5 A. For a typical 0.5 HP or 1 HP household pump, let the switch drive a relay or contactor coil so the heavy current never passes through the float.
Is it normally open or normally closed?
Both are possible. The vertical design lets you mount it one way for a normally-open contact and flip it for normally-closed, so the same unit suits fill-up or drain-down logic.
What liquids can it be used with?
Clean or lightly treated water is ideal. Avoid viscous oil, sludge and crystallising solutions, because deposits around the float stop it moving freely.
Can an Arduino read it reliably?
Yes. Use a digital input with the internal pull-up and add a short software debounce, since the reed contact can bounce for a few milliseconds when it changes state.


