Skip to content
Modules

Weighing Sensor 24 Bit Load Cell Amplifier HX711

৳130

The Weighing Sensor 24 Bit Load Cell Amplifier HX711 turns a strain-gauge load cell into clean digital weight readings for Arduino, ESP32 and ESP8266. Digital scales for coursework and science fairs, smart kitchen and luggage scales, and weight logging in IoT builds all start with this board, and its 24-bit delta-sigma ADC resolves just a few grams on a typical 1 kg to 20 kg load cell.

  • Two differential input channels (A and B) with selectable gain of 32, 64 or 128
  • Output rate selectable, 10 or 80 samples per second
  • Connects over just two wires, DT and SCK
  • Load cell terminals E+, E-, A+ and A-; supply 2.6 to 5.5V

Bolt the load cell to a rigid base with proper spacers and let the board warm up a few minutes before taring; mechanical stability matters more than any library setting.

Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.

ADC: 24-bit delta-sigma weighing amplifier (HX711)

Input Channels: 2 differential (Channel A and Channel B)

Gain: Selectable 32, 64 or 128

Output Data Rate: 10 or 80 samples per second

Supply Voltage: 2.6-5.5V DC

Load Cell Terminals: E+, E-, A+ and A-

MCU Interface: 2 wires only - DT (DOUT) and SCK

Serial Clock Range: 200 kHz to 5 MHz (typical)

Supply Current: approx 1.5 mA typical, excluding load cell excitation

Board Size: approx 34 x 21 mm (typical)

Compatible Load Cells: 1 kg to 20 kg full-bridge strain-gauge types

Applications: Digital scales, weight logging, filling control, IoT weight monitors

CategoryModules
Model no.HX711
AvailabilityIn stock
In stock10 pcs
DeliveryCash on Delivery, nationwide Bangladesh

Customer reviews

No reviews yet — be the first.

Questions about the Weighing Sensor 24 Bit Load Cell Amplifier HX711

What is the HX711 weighing sensor module used for?
It is a 24-bit amplifier and ADC that reads the tiny signal from a strain-gauge load cell and passes weight data to a microcontroller, which is the core of any DIY digital scale.
How do I wire a load cell and an Arduino to it?
The load cell wires E+, E-, A+ and A- go to the matching header pins, while the Arduino needs only VCC to 5V, GND to ground, and DT plus SCK to any two digital pins.
How do I get weight readings in code?
Install an HX711 library in the Arduino IDE, run tare() with the platform empty, then apply a calibration factor calculated from a known weight such as a litre bottle of water.
Does it work with ESP32 and 3.3V boards?
Yes, the supply range of 2.6-5.5V means it runs from an ESP32 or ESP8266 3.3V pin, and many builders power the load cell from 5V while reading the data pins at 3.3V logic.
How much power does it need?
The chip itself draws only around 1.5 mA typical, so the real load is the load cell excitation; both together are small enough to share an Arduino or ESP32 regulator in most projects.
Is it beginner friendly?
Yes, it is one of the classic first sensor projects - with a four-wire load cell, a library and one known weight for calibration, most beginners get believable readings within an hour.
Should I use the 10 SPS or 80 SPS rate?
Choose 10 samples per second for steady platform scales where stability matters, and 80 SPS only when you need fast settling, because the faster rate is noticeably noisier.
HX711 মডিউলের দাম কত?
সর্বশেষ দাম Tekko প্রোডাক্ট পেজে দেখুন, ওখানেই আপডেটেড প্রাইস দেওয়া থাকে।
ঢাকার বাইরে থেকে এটা কোথায় কিনবো?
Tekko অনলাইন স্টোরে স্টকে আছে, অর্ডার করলে সারা বাংলাদেশে হোম ডেলিভারি করা হয়।
ডিজিটাল স্কেল বানাতে কেনো করবো এই বোর্ড?
লোড সেলের দুর্বল সিগন্যাল এটা ২৪-বিট রেজোলিউশনে পড়ে দেয়, তাই কয়েক গ্রাম পর্যন্ত নিখুঁত ওজন মাপা যায় — স্কেল প্রোজেক্টের জন্য সবচেয়ে জনপ্রিয় পছন্দ।
আরডুইনোর সাথে কিভাবে লাগাবো?
লোড সেলের E+, E-, A+, A- তার মডিউলের পিনে লাগান, তারপর VCC-GND সহ DT ও SCK যেকোনো দুইটা ডিজিটাল পিনে দিন; লাইব্রেরি দিয়ে tare করে পরিচিত ওজন দিয়ে ক্যালিব্রেট করুন।
নতুনদের জন্য কোন প্রোজেক্ট ভালো হবে?
ডিজিটাল কিচেন স্কেল, লাগেজ ওয়েজিং হুক বা ওজন-ভিত্তিক ট্যাংক মনিটর — এগুলো শেখার জন্য দারুণ আর কম্পোনেন্টও অল্প লাগে।