Skip to content
Capacitors

3300 uf 16v Capacitor

৳9

The 3300 uf 16v capacitor is a genuine bulk storage part, the tall can you place after a bridge rectifier when you want DC so steady a multimeter barely registers ripple. With 3300 microfarads on tap it anchors bench power supplies, battery chargers, amplifier rails and DIY inverter or UPS builds where the load draws in hard surges. The reservoir also covers motor stall current and keeps a 5V logic rail alive through short mains dropouts long enough for a clean shutdown.

  • 3300uF at approx ±20% tolerance, 16V DC
  • Radial through-hole can, approx 13 x 25 mm, 5 mm lead spacing
  • Polarized: longer lead positive, stripe marks negative
  • Rated -40°C to +105°C, 1000 hour load life

Two cautions from experience: charge it through a soft-start or a series resistor, the inrush is real, and always mount it with the stripe to ground. WhatsApp us to order; cash on delivery across Bangladesh.

Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.

Capacitance: 3300uF (3300 microfarads)

Rated Voltage: 16V DC

Tolerance: approx ±20%

Type: Aluminum Electrolytic

Mounting: Radial Through-Hole

Polarity: Polarized — longer lead is positive, stripe marks negative

Lead Spacing: approx 5mm

Body Size: approx 13mm diameter x 25mm height (typical)

Temperature Range: -40°C to +105°C

Load Life: 1000 hours at rated temperature

Typical Uses: Bench supply smoothing, charger and amplifier rails, bulk energy buffering

Soldering: Standard iron up to 350°C, brief contact only; support the can while soldering

CategoryCapacitors
Model no.CAP-3300UF-16V
AvailabilityIn stock
In stock20 pcs
DeliveryCash on Delivery, nationwide Bangladesh

Customer reviews

No reviews yet — be the first.

Questions about the 3300 uf 16v Capacitor

What is this 3300uF 16V capacitor used for?
Bulk smoothing and energy storage — it flattens the DC after a bridge rectifier, holds up amplifier and charger rails during surges, and bridges short mains dropouts in DIY inverter and UPS projects.
How do I wire it into a power supply?
Across the DC output after the rectifier, longer lead to positive and striped lead to ground, as close to the regulator input as practical; add a series resistor or NTC for soft-start because the inrush into 3300uF is large.
Is the 16V rating enough for a 12V transformer supply?
Measure before you trust it — a 12V transformer can peak near 17V before regulation, so for unregulated 12V rails a 25V part is safer, while regulated 12V or 9V outputs sit comfortably under 16V.
Can a beginner build something useful with it right away?
Yes — a bridge rectifier plus a 3300uF filter feeding a regulator is the classic first bench supply project, and it shows ripple on an oscilloscope better than any diagram.
How is 3300uF different from a 2200uF capacitor?
Half again more storage, so measurably lower ripple at the same load current — useful when the supply feeds audio or motor loads; 2200uF stays fine for lighter logic-only rails and costs less board space.
How long does it last and what are the warning signs?
Years at moderate temperature; watch for a domed or bulged top, a hissing or venting smell, a supply that hums audibly, or ripple that keeps growing on the scope — all signs of dried-out electrolyte.
What does it actually do about ripple?
Between rectifier pulses, while the waveform dips toward zero, the capacitor discharges into the load; 3300uF makes that discharge shallow, so ripple falls to millivolts instead of volts.
3300 uf 16v ক্যাপাসিটরের দাম কত?
সর্বশেষ দাম Tekko প্রোডাক্ট পেজে দেখুন — সিঙ্গেল ও বাল্ক প্রাইস ওখানে আপডেট থাকে।
এই বড় ক্যাপাসিটরটা কোথায় পাবো?
Tekko অনলাইন স্টোরে স্টকে থাকে; অর্ডার করলে সারা বাংলাদেশে হোম ডেলিভারি করা হয়।
পাওয়ার সাপ্লাই প্রোজেক্টে কী কাজে লাগে, কেনো করবো?
ব্রিজ রেক্টিফায়ারের পরে রিপল প্রায় শূন্যে নামিয়ে আনে — বেঞ্চ সাপ্লাই, চার্জার, অ্যামপ্লিফায়ার আর UPS ধরনের প্রোজেক্টের মূল ফিল্টারই এই ভ্যালু।
সোল্ডার করে কিভাবে লাগাবো?
লম্বা লিড পজিটিভে, দাগের লিড গ্রাউন্ডে; ক্যান ভারী বলে পিসিবিতে সাপোর্ট দিয়ে বসান, আর সুইচ-অন ইনরাশ কমাতে সিরিজ রেজিস্টর বা NTC ব্যবহার করুন।
নতুন শিক্ষার্থীরা কি সহজে কাজে লাগাতে পারবে?
অবশ্যই — ট্রান্সফরমার, ব্রিজ আর এই ক্যাপাসিটর দিয়েই প্রথম রেগুলেটেড সাপ্লাই বানানো যায়; রিপল আর ফিল্টারিং কনসেপ্ট হাতে-কলমে পরিষ্কার হয়ে যায়।