Tools & Accessories
Breadboard (830 Tie-Point)
৳160
Full-size solderless breadboard with 830 tie points — 630 in the main terminal strips and 200 across the two power rails.
Standard 2.54 mm pitch, so DIP chips, header pins and jumper wires all seat correctly. The centre channel is sized for a DIP package to straddle it with pins on both sides.
What you can build
- Any prototype you want to change without soldering
- Classroom circuits that get rebuilt each session
- Testing a design before committing it to perfboard
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
| Category | Tools & Accessories |
| Model no. | MB-102 |
| Availability | In stock |
| In stock | 6 pcs |
| Delivery | Cash on Delivery, nationwide Bangladesh |
| Tie Points | 830 total |
| Terminal Strips | 630 tie points |
| Power Rails | 200 tie points across two rails |
| Pitch | 2.54 mm, the standard 0.1 inch spacing |
| Model | MB-102 |
| Backing | adhesive pad on the underside |
Questions about the Breadboard (830 Tie-Point)
Are the power rails connected all the way along?
On most full-size boards each rail is split in the middle, with a small gap in the printed line marking the break. If the far end of your rail seems dead, bridge the gap with a short jumper.
What wire gauge fits?
Solid core wire around 22 AWG, which is what pre-made jumper kits use. Stranded wire frays and will not push into the clips, and anything much thicker permanently loosens them.
Can I run mains through it?
No. Breadboards are for low-voltage logic only. The contacts are not rated for mains and the exposed layout is unsafe at those voltages.
More in Tools & Accessories
All tools & accessories →
