Skip to content
Resistors

Resistor 10Ω

৳2

The Resistor 10Ω is a 10 ohm, 0.25W film resistor, the low-ohm part you reach for when a bigger resistance would waste voltage the circuit needs. Current sensing by reading the voltage across it, inrush limiting into big capacitors and small motors, speaker padding and LED string protection are its usual jobs.

  • Bands brown-black-black-gold: 10 Ω at ±5%
  • 0.25 W rating, about 158 mA continuous at 70°C ambient
  • A handy sense ratio: 0.1V across it means 10 mA flowing
  • Axial through-hole, no polarity, breadboard friendly

Check the current math before substituting a different low-ohm value in a load-limiting role.

Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.

CategoryResistors
Model no.RES-10R-025W
AvailabilityIn stock
In stock90 pcs
DeliveryCash on Delivery, nationwide Bangladesh
Resistance10 Ω
Tolerance±5%
Power Rating0.25 W (1/4 W) at 70°C ambient, derate above
TypeFilm resistor with insulated epoxy coating
Temperature Coefficientapprox ±250 ppm/°C
Max Working Voltageapprox 1.6 V continuous (power limited at this resistance)
Colour BandsBrown - Black - Black - Gold
PackageAxial Through-Hole
Lead Diameterapprox 0.55 mm, pre-tinned copper-clad steel
Lead FormStraight axial, breadboard and 2.54 mm grid friendly
Body Sizeapprox 2.5 mm diameter × 6.5 mm length
Operating Temperature-55°C to +155°C
Quantity1 piece per unit ordered

Customer reviews

No reviews yet — be the first.

Questions about the Resistor 10Ω

Why would anyone use a resistor as small as 10 Ω?
For current sensing, inrush limiting, speaker padding and output protection, jobs where a larger resistance would waste voltage the circuit actually needs.
How does it measure current?
Place it in series with the load, measure the voltage across it with a multimeter, and divide by 10. So 0.1 V across the resistor means 10 mA through the circuit.
What current can it carry continuously?
The 0.25 W rating allows about 158 mA continuously at 70°C, which corresponds to roughly 1.58 V across the part.
How do the bands Brown-Black-Black-Gold read?
Brown is 1, black is 0 and the black multiplier adds no zeros, giving 10 Ω, with gold marking the ±5% tolerance.
What do pairs of them give me?
Two in series give 20 Ω and two in parallel give 5 Ω, handy for halving a sense value or doubling the inrush protection.
Does polarity matter when I insert it?
No, resistors are symmetric and work the same either way round.