
Resistor 3.3k Ω
- Fresh, latest-batch stock — never old shelf stock
- Tested before it ships
- Arrives dead? We replace it
- Same-day delivery in Dhaka · Cash on Delivery nationwide
- See it before you buy: visit our shop at Ansar Ali Sarak, Boat Ghat, East Nurer Chala, Vatara
The Resistor 3.3k Ω is a 3300 ohm film resistor that sits where LED work and bus pull-ups overlap. It also trims transistor emitter currents and sets op-amp gains.
- Bands orange-orange-red-gold: 3.3 kΩ at ±5%
- Film element, steady through a long lab session
- 0.25 W rating at 70°C ambient, derated above that
- Axial through-hole leads fit breadboard and 2.54mm PCB grids
Sold per piece, so match the count to your BOM.
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
Resistance: 3.3 kΩ (3300 Ω)
Tolerance: ±5%
Power Rating: 0.25 W (1/4 W) at 70°C ambient, derate above
Type: Metal Film resistor, insulated epoxy coating
Temperature Coefficient: approx ±100 ppm/°C
Max Working Voltage: 250 V
Colour Bands: Orange - Orange - Red - Gold
Package: Axial Through-Hole
Lead Diameter: approx 0.55 mm, pre-tinned copper-clad steel
Lead Form: Straight axial, 2.54 mm breadboard and PCB friendly
Body Size: approx 2.5 mm diameter × 6.5 mm length
Operating Temperature: -55°C to +155°C
Quantity: 1 piece per unit ordered
| Category | Resistors |
| Model no. | RES-3K3-025W |
| Availability | In stock |
| In stock | 100 pcs |
| Delivery | Cash on Delivery, nationwide Bangladesh |
Customer reviews
No reviews yet — be the first.
Questions about the Resistor 3.3k Ω
What does a 3.3 kΩ resistor do well?
It limits LED current on 5 V rails, provides a firm pull-up on I2C and one-wire buses, biases transistors, and sets op-amp gains in the low thirties.
How do the bands Orange-Orange-Red-Gold decode?
Orange is 3, orange again is 3, red multiplies by 100, so 33 x 100 = 3300 Ω, and gold marks the ±5% tolerance.
How much current does it feed an indicator LED on 5 V?
Roughly (5 V minus 2 V) divided by 3300 Ω, close to 1 mA for a standard red indicator. Modest but clearly visible on panel work, and gentler on the LED than 470 Ω.
Is it a good I2C pull-up choice?
Yes, it gives crisper edges than 4.7 kΩ on long or crowded buses. Just confirm the total sink current stays within what the pins allow.
Can I parallel two of them?
Two in parallel give 1.65 kΩ and two in series give 6.6 kΩ, handy when the drawer lacks those exact values.
Will it overheat on a 5 V rail?
No. 5 V across 3300 Ω dissipates about 7.5 mW, a tiny fraction of the 0.25 W rating.


