Skip to content
Sensors

Load Cell 10kg with HX711 Amplifier

Contact for price

A 10 kg strain gauge load cell paired with an HX711 amplifier board, the standard combination for a digital weighing scale on an Arduino or ESP32. The load cell is a metal bar with strain gauges bonded inside; the HX711 reads the tiny resistance change with its 24-bit ADC and passes it to your controller over two wires, clock and data. Mount the cell so force passes through it as designed, tare with the platform empty, and calibrate against a weight you trust, and you have a working scale for a kitchen, a shop counter or a small hopper.

  1. 10 kg capacity load cell
  2. HX711 24-bit ADC amplifier board included
  3. Two-wire connection to the microcontroller (SCK/DT)
  4. Typical builds: digital scales, load monitoring, small silo weighing

The HX711 Arduino library handles the timing. Start from its example sketch, call tare() with the platform empty, then find your calibration factor with a known weight.

Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.

Capacity: 10kg

Amplifier: HX711 24-bit ADC

Interface: 2-wire (SCK/DT)

CategorySensors
Model no.LOADCELL-10KG-HX711
AvailabilitySourced on request — ask for price & lead time
DeliveryCash on Delivery, nationwide Bangladesh

Customer reviews

No reviews yet — be the first.

Questions about the Load Cell 10kg with HX711 Amplifier

What can I build with a 10 kg load cell and HX711?

Digital scales are the usual project: a kitchen or shop counter scale, a feed or hopper monitor, or force measurement on a small rig. Anything that needs weight read into an Arduino or ESP32.

How do I wire the load cell to the HX711 and Arduino?

The load cell's four wires (excitation plus and minus, signal plus and minus) go to the HX711 screw terminals, then the HX711 connects to the Arduino with two data lines plus power. Wire colours are not standardised between suppliers, so check your cell's datasheet before soldering.

Why do my readings drift or jump around?

Mounting is usually the cause. The load cell needs a rigid base and a platform so force passes straight through it, and the reading needs a tare at start-up. Temperature also shifts the zero, so re-tare for long sessions.

How do I calibrate it?

Record the raw value with nothing on the platform, place a weight you know, record the new value, and divide the difference by the weight. That factor converts raw readings to grams or kilograms in your code.

Can I weigh more than 10 kg with it?

Overloads past the rated range can bend the cell permanently, so stay inside it. Exceeding the rated capacity can permanently deform the element and ruin the zero. Pick the 20 kg cell if your load runs close to the limit.

HX711-এর জন্য কোন লাইব্রেরি লাগবে?

Arduino-তে bogde/HX711 লাইব্রেরিটাই সাধারণত ব্যবহার হয়, ESP32-তেও চলে। লাইব্রেরির সাথে আসা উদাহরণ স্কেচ দিয়েই tare আর ক্যালিব্রেশন শুরু করা যায়।