
Tools & Accessories
Project Enclosure Box (ABS, Small)
Contact for price
- Fresh, latest-batch stock — never old shelf stock
- Tested before it ships
- Arrives dead? We replace it
- Same-day delivery in Dhaka · Cash on Delivery nationwide
- See it before you buy: visit our shop at Ansar Ali Sarak, Boat Ghat, East Nurer Chala, Vatara
Small ABS enclosure of roughly 100 x 60 x 25 mm, the size that suits a finished project built on a single Arduino or ESP32 board with a small module and short wiring. ABS takes drilled holes well, so switch and connector cut-outs are straightforward to add.
- Material: ABS plastic
- Approx. 100 x 60 x 25 mm (model dependent)
- Fits a dev board, a sensor or two and a small battery
Check the tallest component on your board against the lid clearance before committing to this size.
Not sure it will work? Test your circuit free in Tekko Sim — on your phone, in Bangla or English.
| Category | Tools & Accessories |
| Model no. | ENCLOSURE-ABS-SMALL |
| Availability | Sourced on request — ask for price & lead time |
| Delivery | Cash on Delivery, nationwide Bangladesh |
| Material | ABS plastic |
| Size | Small (approx. 100x60x25mm, model dependent) |
Customer reviews
No reviews yet — be the first.
Questions about the Project Enclosure Box (ABS, Small)
Will an Arduino Uno fit inside?
The board fits the roughly 100 x 60 mm floor, though the USB socket lands right at the edge, so plan a cut-out for it. An Uno with a full-size shield usually needs the large box instead.
Can I drill holes for switches and cables?
Yes. Mark everything before drilling, start with a small bit and step up, and deburr so cables are not chafed.
Is ABS alright for outdoor use?
Indoors it is fine. Long exposure to sun degrades ABS, and heat near a radiator or engine can warp it, so keep an outdoor build shaded or painted.
How do I stop the board rattling inside?
Foam tape under the board, standoffs or a dab of hot glue at the corners hold it still. Close the lid without it pressing on components.
ছোট বক্সে কী কী রাখা যায়?
একটা Arduino বা ESP32 বোর্ড, এক-দুইটা ছোট মডিউল আর ছোট ব্যাটারি ফিট করে, ছোট প্রোজেক্ট বন্ধ করে রাখার জন্য যথেষ্ট।


